ENG
Linear lamp
Due to the design features of the luminaire, please note that there will be a dark zone of about 5 cm on the sensor side (with blue illumination) and, depending on the length L of the luminaire you ordered , a dark zone of up to 5 cm is allowed on the second side of the profile.
Which side to control the sensor You decide when installing the luminaire, as the linear luminaire is symmetrical.
FYI: The power wire is always on the side of the sensor.
Linear luminaire for 2 zones
Please note: the kitchen surface is divided into 2 parts by the hob. Usually there is own lighting above the hob, so it is logical to divide the lamp into 2 parts: L1 and L2 . In this case, control sensors can be either separately for each luminaire: S1 or S2 and S3 or S4, or combined for two luminaires: S1 or S4. When ordering, please specify the desired location of the sensor(s). FYI: The power wire is always on the side of the sensor.
Installation of a linear LED profile
The LED profile is supplied with two brackets for profile lengths up to 2.0m and three brackets for profile lengths from 2.0m to 2.9m (picture C).
If the kitchen cabinet is no more than 5mm behind the wall (picture A), then firmly press the bracket to the wall and to the bottom wall of the cabinet and screw it using the screw from the kit. The recommended distance from the edge of the LED profile to the bracket (picture B) is 0-10 cm.
For profiles longer than 2.0 m, it is recommended to install an additional 3rd bracket closer to the middle of the profile.
If the gap between the cabinet and the wall is more than 5mm, then you can screw the brackets indented from the wall or to the side walls of the cabinets (see the following figure).
Installation of a linear LED profile
There are such designs of kitchen cabinets where it will not work to press the LED profile tightly to the cabinet - the side walls of the cabinets protrude beyond the dimensions. In this case, we recommend installing brackets on the ends of the side walls, which fit snugly against the wall (figure A).
Installation of a linear LED profile
After installing the profile in place, proceed to pulling the power wire. We recommend installing the power supply on a cabinet and running the wire behind or to the side of the cabinet. To avoid overheating, do not cover the power supply with foreign objects ! Connect the two plugs together, and pull the excess wire up.
Installing a linear LED luminaire
Connect the power supply to the 220V network. Depending on the configuration you choose, it will be either a standard 220V plug (1) or Wago terminals (2).
We remind you: observe the safety measures when connecting the terminals! All connections must be made with the 220V line disconnected!
If you doubt your qualifications , entrust the work to professionals!
Installing a linear LED luminaire
A blue glow around the sensor will confirm that the connection is correct.
Luminaire control:
- Short touch: turn on/off the luminaire
- Long touch: increase/decrease brightness